 Check and Clean Inside Cooling Coil, If
Accessible: Foreign material on
the coil reduce air conditioning system must run longer, increasing
energy consumption and raising your cooling costs.
Clean Primary and Secondary
Drains: A clogged condensate
drain can cause considerable water damage and will increase humidity
levels.
Check and Clean Condenser
Coil: Foreign material on the
condenser coil reduces the system's cooling capacity to remove heat
from the house. A dirty coil will increase your cooling cost by 30%
or more and can shorten the life of your air conditioner.
Check Operation Pressures for Proper
Refrigerant Charge: Improper
refrigerant charges - too much or too little - can damage the
compressor and will cause high electric bills and reduced cooling
capacity due to inefficient equipment operation.
Adjust and Clean Blower
Components: Proper adjustment and
cleanliness of blower and components is necessary for adequate air
flow to assure maximum cooling performance. |
Monitor Air Conditioning
Cycle: Our trained Serviceman
will assure that the air conditioner is "cycling" on and off
properly.
Lubricate All Moving Parts Where
Applicable: Poor lubrication
causes drag in the motor and drive shaft, thereby requiring more
electricity to overcome resistance. This condition will cause early
motor or bearing failure.
Monitor Voltage and Amperage Draw On
All Motors: Motors are designed
to operate at standard voltage and amperage draw. By measuring
amperage draw, problems can be identified before the unit
fails.
Check and Tighten All Loose Electrical
Connections: Loose electrical
connections are a common source of problems which cause your
electrical parts to fail and your air conditioner to become
inoperative.
Clean and Adjust Thermostat:
To ensure even temperature control for your
home.
Make Recommendations: To improve the operating efficiency of your air
conditioner. |
